Questions & Answers

EVO-VWT1 is not flashing RED YELLOW BLUE, Just stays at RED

0 votes
When I want to program the EVO All module, it just shows solid RED light. Other lights are not flashing.

How can I reset it?
posté depuis 3 semaines dans la catégorie Audi par idris.mousavi@gmail.com (160 points)

1 Réponse

0 votes
Hello,

Here are the steps to resolve the red led stuck on:

https://www.wirecolor.com/en/qa/92073/faq-red-led-stuck-on?show=92073#q92073

Best regards
répondu depuis 3 semaines par Derek J (400,160 points)
Where can I find flash version 0.99?

It is not showing on the flash version list.
commenté depuis 3 semaines par idris.mousavi@gmail.com (160 points)
What is the S/N number to the module in question?

Thank you.
commenté depuis 3 semaines par Derek J (400,160 points)
It's 001A08006344.
commenté depuis 3 semaines par idris.mousavi@gmail.com (160 points)
What step in the programming does not work for you?

https://fortin.ca/download/99061/EVO-ALL_IG_RTS_BI_VW1-Q3-2015_PTS_TB_B_99061.pdf
commenté depuis 3 semaines par Derek J (400,160 points)
Step 2 of programming, "Press and hold the programming button: Connect the 4-PIN Data-link harness (Black connector)" when I connect the 4pin connector, just the red LED is up solid.

I've been told to flash with version 0.99.

Just don't know where to find that version.
commenté depuis 3 semaines par idris.mousavi@gmail.com (160 points)
Can you please re flash firmware 67.12 into the unit and then re attempt the in vehicle programming. To do this click on "view other firmware" and simply re select 67.12.

Thank you.
commenté depuis 3 semaines par Derek J (400,160 points)
I've already done that with no success, the RED LED is still solid and the other LEDs are not flashing.
commenté depuis 3 semaines par idris.mousavi@gmail.com (160 points)
Just to be sure, you are holding down the programming button while plugging in the black 4 pin connector from the VWT1 t-harness correct?

Can you please select any other car, example a ford or a toyota, load that firmware into the unit and then see if you are able to cycle through the led colors in the vehicle.

Best regards
commenté depuis 3 semaines par Derek J (400,160 points)
I'm holding down the programming button while plugging in the black 4 pin connector from the Flash-Link 4.
I have updated firmware v71.64 for a ford into the unit but the RED color LED was still ON.
I reloaded firmware v67.12 again with no change, RED LED is still ON.
I am also getting close to flash limit (7/8)..
commenté depuis 2 semaines par idris.mousavi@gmail.com (160 points)
I would suggest phoneing into the tech line at this point so an agent can go over it with you. Please be sure to have access too the mdoule, flash link and vehicle when calling.

An agent can also reset your flash limit as well.

1-877-336-7797

mon - fri

8am - 6pm est

Best regards
commenté depuis 2 semaines par Derek J (400,160 points)

Questions associées:

...