Stability and TPMS Fault

Question

Evo-Rs on 2012 Audi q5 with T harness. After install and operation the stability and TPMs faults pop on screen   What is causing the issue as there are other pending faults

Answer 1

Hi Robert Martins,

 

Yes weak or bad can bus connections can cause faults in vehicles. 

 

If any type of quick connector was used to make the connection remove it and use the poke and twist method to connect the wire, additionally if it was soldered this can add resistance to the can bus and also cause a fault. 

Remove the can bus connections and ensure there are no more faults, then re connect the can wires. 

 

Also ensure all connectors were properly seated and clipped into their socket. 

Wouldn't hurt to inspect the pins of the connectors also to ensure that a pin was not bent or pushed. 

 

Best regards