Questions & Answers - Questions récentes tagguées #rx350

RX350, LX600

Thu, 24 Sep 2026 17:48:01 +0000

Hello. On the 2024 Lexus LX and RX, the factory alarm does not disarm when using the mechanical key in door. Must unlock the doors using the remite to prevent the factory alarm from triggering. If we install an aftermarket alarm system and unlock the doors using the new system's remote, the factory alarm will go off, right?

2018 lexus rx350 evo all stand alone

Wed, 13 Nov 2019 23:09:25 +0000

need some help with a 2018 rx350 i installed a evo all stand alone and hard wired everything, it programs fine but does not start, the evo all doesnt flash when i press lock but if i turn igntion on it lights up yellow. i tried different firmwares and still same thing, i also double checked all wires if anyone knows the issue let me know

thanks

i plugged in a evo one i had and programmed it to 3x lock and it started, so is it possible the evo all is defective?

2017 RX350 + EVO-ONE + RFK942 + THAR-TOY6 remotes not performing actions

Sat, 02 Nov 2019 21:16:53 +0000

I'm doing installation on a 2017 RX350 using EVO-ONE, RFK942 and THAR-TOY6 harness.

I have the B plug from harness going into the main body ECU connector as per instructions. Black steering lock connector connected as per instructions. Doors plug hooked up to the EVO-ONE plug within the harness.

EVO looks to be taking programming, following the steps results in blue LED flashing quickly which is finished by turning off ignition. Seems good.

I got the remotes programmed to the RFK942, pressing buttons results in green LED lighting up on the antenna and the remotes respond with green LED and beeps.

The problem is the remote buttons result in no actions being taken. No locking, no unlocking, no starting.

If I hook up the antenna directly to "Data Link Antenna" port on EVO nothing happens when trying to lock, unlock or start. It confirms with green LED and beeps. No LED activity on the EVO.

If I hook up th antenna to the blue plug on the harness, which splits from a connector that plugs into data link port, then again nothing happens if door lock/unlock is requested. If start is requested than the car locks, dash lights up and goes into ignition mode, blinkers blink a few times, no start attempt. RED and Orange LEDs on the EVO light up and stay lit.

Car functions normally with stock remote.

I've done a ton of googling, looking through various PDFs but can't find anything wrong with what I'm doing.

Thanks :)