2018 CRETA

Question

I installed the Evo-One on a 2018 Hyundai Creta (selecting the Kona model). It works well, but where can I find the wire for the "Take Over" function, so the engine doesn't shut off?

Answer 1

Hello, 

It is located on the White 38 pin connector on the back side of the fuse box, pin 12, same connector as the starter connection. 

https://fortin.ca/download/73971/EVO-ONE_IG_RTO_BI_KIA7-KONA_2018_PTS_B_73971.pdf

#28 in the picture below

Best regards

Comments

But here, I found all the other wires in a completely different place. The connectors here are totally different. Where is this wire actually coming from, so I can look for it elsewhere?

---

2018 Kona info:
Connector I/P-E at IGPM module, Pink, Pin 12 - Fuse - PDM 3: Smart key control module, immobilizer module. 

---

I'll temporarily connect our wires in place of these PDM fuse and see what happens.

---

I cut all the pink wires, but that didn't help. I'll just leave it as is. The CAN-A lines (orange and green wires) were in the left gray connector behind the fuse box. ACC was there too—a green wire. Ignition (pink) and Starter (thin white) were in the right black connector behind the fuse box. EMS (blue-black) was in the kick panel. The start-stop wires were pink-black and green... pins 9 and 10. The wire for the parking lights was brown. CAN-B red and blue at OBD...Thank you