Questions & Answers - Recent questions tagged stuck

Key Bypass Programming stuck at Step 5 on 2009 Honda Civic Evo-One w/ T-Harness

Mon, 07 Sep 2026 23:26:46 +0000

Hello,

I get stuck at Step 5 when trying to program key bypass.

1) Press and hole programming button while connection 6-pin main connector.

2) Released the programming button when the led is Red

3) Inserted the remaining connectors (A-20-pin,D-Red,C-White,B-Blue)

4) Pressed and released programming button twice (x2). Red led flashes once per second.

5) Turned key to On/Run position. Leds turned off. (Should have flashed red 10 times then blue flashing.) This is where I get stuck every time. I did notice that if I remove the 20-pin at this point, then the leds flash properly (Red x10. Blue rapidly) I replace the 20-pin and try to prepare remote start but nothing happens.

Thank you.

Evo one programming, stuck on first step, leds alternating in a loop

Tue, 06 Jan 2026 19:50:32 +0000

2023 corolla hybrid h key, connected all wires like it says in the manual. Pressing the learn button and connecting the 6pin but it never turns solid blue. Just keeps alternating leds. Tried changing to default all the options, didn't help. I did mess up on first step when connected the t harness and then saw that you have to press the button and then connect only 6 pin for the first step.

Audi 2013 S4 DSG - Fortin ALL getting stuck on step 7 with 3 x red flashing lights

Fri, 22 Dec 2023 11:16:42 +0000

Just installed a Fortin ALL with the Audi T Harness on a 2013 Audi S4 DSG. UK right hand drive car.

When I go to try and get the unit to read the key data I am just getting 3 red light flashes on step 7, everything is fine up until that point and the car operates as normal.

When I then put the flashlink back onto the PC software it says invalid key data. Any ideas? I have checked all wiring, also checked status of CANBUS with zero issues showing so I know that wiring is good.

Serial no for module is : 001A07445150

2013 Toyota Corolla Evo-All stuck on step 5 in programming procedure

Tue, 21 Jan 2020 17:10:12 +0000

Hi, I installed a remote start on a 2013 Toyota Corolla that uses the Evo-All bypass module. I am currently stuck on step 5 of the programming procedure on page 3. When I turn the key to the on position the blue and red led light from the previous step turn off and nothing happens. I checked all the wiring going to the ODBll with a multimeter and everything seems fine. The remote start does crank over the engine but will not start unless the key is close to the ignition. Does anybody have any suggestions?