Questions & Answers

2019 Jeep Cherokee EVO-ALL won’t start

0 votes

    I need help. I've been a couple days now with this. EVO-ALL installed programming goes fine, but it will not tun over the car. Module comes to life on 3x lock, cycles the gauges, but then just stops and tries again. 
    asked Sep 11 in Jeep by Ryan Lehman (240 points)

    2 Answers

    0 votes
    Hello,

    What is the S/N number to the evo-all?

    Was a t-harness used? If so which one?

    Also can you please provide the entire vin number to the vehicle in question.

    Best regards.
    answered Sep 11 by Derek J (400,160 points)

    SN 001A07 734548

    EVO-ALL CHRT7

    1C4PJMBX3KD246209

    commented Sep 11 by Ryan Lehman (240 points)
    Doesn’t allow takeover either. If pedal is down it’ll start, then stop if pedal is pressed again
    commented Sep 11 by Ryan Lehman (240 points)
    Please enable option D6-push to start, save the option and then re test it in the vehicle.
    commented Sep 11 by Derek J (400,160 points)
    0 votes
    It seems to only work if I press the brake pedal
    answered Sep 11 by Ryan Lehman (240 points)

    Related questions

    ...